Best Power Unity/I UT3K Instalační manuál stáhnout pdf (Strana 29)

Notes for Figure 9L and 9M

NOTE 1: Connect the UPS’ green and yellow neutral-to-ground (neutral-to-earth) wire (N-G bond) to the UPS

output terminal indicated.

NOTE 2: See Table 11 on page 25 for maximum output current ratings.

* See Section 304, step 5, for instructions on setting the Output Voltage Reference parameter.

303 Installing the Overcurrent Protection Devices

❑1. Install the UPS input circuit breaker at the service panel. See Table 6 on page 8 and your instal-

lation wiring diagram.

❑2. Install the UPS output overcurrent protection device at the UPS output. See Table 7 on page 9

and your installation wiring diagram.

❑3. Install the load current circuit breakers or fuses.

• The load current per phase (leg) must not exceed the value listed in Table 11.

• Size per local code requirements.

1 2 ... 24 25 26 27 28 29 30 31 32 33 34

Žádné komentáře

Best Power Unity/I UT3K Instalační manuál Strana 29